Archief - pc valt uit (van de warmte ?)

Memtest86 is a stand alone program and can be loaded from either a disk
partition or from a floppy disk.

To build Memtest86:
1) Review the Makefile and adjust options as needed.
2) Type "make"

This creates a file named "memtest.bin" which is a bootable image. This
image file may be copied to a floppy disk or lilo may be used to boot this
image from a hard disk partition.

To create a Memtest86 bootdisk
1) Insert a blank write enabled floppy disk.
2) As root, Type "make install"

To boot from a disk partition via lilo
1) Copy the image file to a permanent location (ie. /memtest).
2) Add an entry in the lilo config file (usually /etc/lilo.conf) to boot
memtest86. Only the image and label fields need to be specified.
The following is a sample lilo entry for booting memtest86:

image = /memtest
label = memtest

3) As root, type "lilo"

At the lilo prompt enter memtest to boot memtest86.

If you encounter build problems a binary image has been included (precomp.bin).
To create a boot-disk with this pre-built image do the following:
1) Insert a blank write enabled floppy disk.
2) Type "make install-precomp"

Klik om te vergroten...